1. Welcome to TalkBass 2014! If you're new here, we just went through a major site upgrade. Please post all concerns and bugs to the Forum Usage Issues forum. We will be monitoring that forum. Thank you for all of your feedback.

    The TalkBass iphone/android app is NOT WORKING currently. We're working on it. Tapatalk IS working, so if you need to use an app, use Tapatalk. Try using your browser though - TalkBass is now 100% responsive to your phone/tablet screen size ;)

    Please read the TalkBass 2014 FAQ for lots of great info on the new software.

Cable Making- Help needed.

Discussion in 'Pickups & Electronics [BG]' started by Etchbass, Aug 8, 2011.

  1. Etchbass

    Etchbass

    Joined:
    May 22, 2011
    Likes Received:
    0
    Hi,

    I have been making my own cables for a while now and all was going well, for the most part. However, I'm having some trouble with unwrapping tightly braided shielding when stripping cables. I recently purchased some gepco xb20 and it is dual braided shield. I wind up with way too thick of a wrapped ground when I go to solder the cable. When I try to cut away excess, I'm not sure how to handle the little small wires around the insulation.

    Any helpful tips? Thanks!

Share This Page