1. Welcome to TalkBass, the Premier Bass Player Community and Information Source. Register a FREE Account to post and unlock tons of features!

Finish question? Cirrus

Discussion in 'Luthier's Corner' started by Medic579, Apr 1, 2014.


  1. Medic579

    Medic579

    Dec 18, 2009
    Tallahassee
    Ok I just bought a us peavy cirrus 5 it's a walnut top and body with pau Ferro board. It has a worm spot and I want to get it looking smooth again. I did oil it and them wipe it with a clean cloth. I used fret dr. Which has lemon oil and a few other oils. I've used it on fretboards before. Anyway I was told a very light sanding with 0000 steel wool would smooth it then I could reoil it. Would appreciate any help on this.

    Before oil:

    [​IMG]

    After Oil:

    [​IMG]
     
  2. Rano Bass

    Rano Bass

    Sep 9, 2006
    Tijuana Mex.
    If your bass has an oil finish you can sand it very carefully and then oil it again.
     
  3. Sponsored by:

  4. Medic579

    Medic579

    Dec 18, 2009
    Tallahassee
    What would you use to sand it? 0000 steel wool. Or a fine grit sandpaper?
     



Share This Page