Loaded Warmoth P Bass body with a Seymour Duncan SMB-4a (alnico) MM bridge pickup and a S. Duncan SJB-1n vintage Jazz Bass neck pickup. EMG 2 band 9volt/18volt active eq., BTS controls 2 vol., 2 tones (1 bass & 1 treble with center indent). Treble indent can be changed to 4 diffent freq. via a micro switch in the control cavity. EMG instructions included. Currently wired for 2, 9 volt batteris, 18 volt. Can be switched to 9 volt if desired. (A black Sharpie marker was used to stain out the ugly Basslines logo on the SD MM pickup.) Warmoth body is swamp ash with 1/8" quilted maple laminate top. Warmoth factory trans blue finish. Body weight without hardware is 5.1 lbs. (average weight). Condition is 97% to 99% of mint. Three micro dings that are hard to find and extremely light finger nail swirls under the pickups. You can go to Warmoth and S. Duncan and EMG and do the math on this loaded body. Being sold for much less than 1/2 of build price. 2 prices on this loaded body. $299 + $24 for shipping minus the Schaller bridge (sold without a bridge). (body has factory holes for 5 screw Fender or BadAss) (and 2 extra holes for a Schaller) $299 + $50 for Schaller bridge + $24 for shipping. USA 48 only. PayPal FedEx Ground shipping. An extemely OUTSTANDING looking Warmoth bass body! (photos have reflections of over-head wires and trees) Neck not included!