Separate names with a comma.
Well, i'm doing a DIY cab of the Ampeg svt15e, but i dont have the measure of the ports or vents. I dont know anyone who has it. They do not have...
Again, I have been playing around with the same old 10" genz-benz faitals in what was a sealed box. I cut a 4" hole in the cab in the front,...
Ok Cabinet Gurus: I have a box (currently sealed) with a vb 2.28 ft3 made out of 3/4" plywood. I've installed an eminence defeat-able 250hz LPF. I...
I scored on Craigslist with some gear hoping I can get some assistance from those with software that can tell me the correct port length needed...
Missing cardboard tube
Here's something silly and fun for your Saturday afternoon. Jaco's beastly (but likely sped up:) ) solo on Port of Entry, played on upright! I had...
Have a great little combo amp, the GK MB150S/112. Long since out of warranty, Ive been thinking about modding it by adding some bass port tubes to...
Hi, I was wondering if anyone could cast their eyes over this? I'm no good at math and working out the numbers doesn't work for me as I don't...
Several 1x15" cabinets I've demoed in stores farted out early when I pushed them at low frequencies. Some of these 15" cabs were supposedly...
The enclosure is about 3.7 cubic ft, with two Genz Benz 10pr300s from Avatar. It's sealed now, and Winisd says it should have pretty poor output...
So Ive got this speaker cabinet. Its made by a well known brand, which I wont mention cos I dont want to hear why I shouldnt do this based on the...
