signal chain

Did a quick search and didn't really find anything on this specifically, but I'll post the full story and a tl;dr at the bottom for the essence of...

After not owning a single pedal, and spending months trawling TalkBass for reviews, questions, feedback and advice, I've just purchased a bunch of...

Hi everyone! I´d like to send a clean DI signal to FOH, but I´m not sure where to put it in my signal chain (before or after my tuner). Does...

So I have a Darkglass Microtubes X Ultra that I use as a preamp pedal (EQ and Cab Sim). Where should I put it in my signal chain (I'm running a...

Hey guys, I’ve been battling with my Cat Demon from fuzzrocious for some time now. Making it work in my signal path is a pain. Turn it down too...

I have an Ibanez SRMS805 bass, and a Mesa WD-800 head going into a 1x12 Darkglass cab. I’m happy with my tone for the most part, except I kind of...

I am trying to record my bass dry and wet signal to Logic Pro using the following signal paths: Signal path 1 Bass -> Tonebone (Radial Bassbone)...

Hello Talkbass community, something I have been wondering about, I have asked this question to some friends of mine, engineers, producers,...

I recently purchased a used Gallien-Krueger 700rb ii head & Neo 212 ii cabinet & am hoping to get some direction on how to properly use the FX...

I currently have the Broughton Audio JoshWah which has a good amount of gain in its own right that you can dial in to throw some dirt on the...

Hallo! I’m looking for some help, as I’ve just purchased an Eden Navigator Pre-Amp that should be arriving in a couple of days, but I’m unsure as...

Hey guys, I was having trouble understanding the difference between AB boxes, ABY boxes, and Combiners. For example the Morley AB/ABY Box. The...

Good morning TalkBass. Recently swapped out my Jazz Bass pickups. When adjusting the height of the neck pickup I noticed a tapping sound coming...

[ATTACH] Hi, I’m new here, first post. I have some decent knowledge, always seeking more though. First I’ll give you the facts, then ask the...

Hey TB! I've been trying to use my Aftershock as a blend pedal. The manual says that I can send it two inputs and get one output. Seemed...

Hi all, so I recently nailed down my array of pedals for the foreseeable future and I just have one last question re: placement before I’m all set...

For those of you that use a high pass filter, what is the most effective location in the signal path? Do you place it before the amp, in the...

After getting a new job, cheaper apartment, and a security deposit check in the mail I'm splurging on new gear. I'm getting a Verellen Meatsmoke...

Has anyone seen pedals that do this? I'm trying to set up some sort of twin isolated effect path that gets joined together. Ive seen a/b boxes,...

I usually run just a compressor. Feed that to my amp and FOH. Now that I'm moving to IEM, I find the bass sounds overly bright and I'm thinking...

Hi all. My pedalboard setup defies a lot of the common consensus on signal chain order: [ATTACH] TU2 > Saturn V (boost and slight grit) >...

Not sure what category to put this in but as it happened last night at a gig I will go for live sound. Basically since using a pedal board,...

I’m trying to figure out how to record the clean lows and distorted highs at the same time using Logic Pro x with my darkglass amp. I saw in the...

I'm not sure if this belongs here or not, but here it is: I just got and installed my Ampeg SCR-DI. The signal path is : bass output to Planet...

What's up, TB? It's been a hot minute I'd say. I got a quick question for you guys and gals regarding my tone with a Boss DD-3 digital delay...

Hi guys, I just got an Acoustic B410C cabinet (400W) that I'm powering via my Ampeg BA-210 V2 (450W). The Acoustic cab has an 8ohm impedance,...

Hello everyone! I am about to put my hands on one of these lovely gems. I was curious to know from those of you who regularly use it live, where...

Hi everyone. I have a new pedal board setup, & I think everything is hooked up properly but no signal. The setup is as follows: Preamp to...

Hey TalkBass Effects Discussion, Firstly, heres a link for your perusal Red Panda: Tensor I'm about to pull the trigger on the Red Panda Tensor...

This may be a question for the effects forum, but I am adding a Broughton HPF/LPF to my bass set up. It is the only effect in my signal chain and...

So, I’m pretty stoked on the Darkglass AOU. I just got pretty close to pulling the trigger on the Omicron but am thinking the extra...

Hello everybody, My bandmates are having some issues adjusting to this bass' voice range. Also, my technique is telling right now and I have to...

Hi Community, So I finally bought my Ampeg V-4b. Great Amp with an AV 212 Cab, great tone and so simple. Not to much Settings on the EQ and...

When things go wrong with your gear, what's the primary culprit? The cable...always check the cable! What about when everything's working fine?...

Man, I hate that I'm that guy asking for signal questions... that said, here we go: Thoughts on this: Bass=> Radial Bassbone OD input A =>...

Sorry if this has been posted already. Premier Guitar posted as of 28 Nov 2017 the latest rig rundown and in-depth signal chain for Duff Mckagan's...

[ATTACH] So my chain currently goes bass>tech 21 vt>gk amp>effects loop out>boss es-5>mooer spark compressor>effects loop in Even without any of...

Ok I've got a bit of a problem that I can't get my head around... I'm getting clipping/distortion from my rig when hitting low notes on the B and...

Hey guys, So I am pretty new to signal chains and having a lot of pedals. Currently my pedalboard is as simple as it gets - Korg Tuner ->...

Hi people! I'm fairly new here. And I've been trying to figure out what would be the best way to set-up my signal chain. And I'm not a super pro...