1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

3-way rotary pu switch wiring help wanted

Discussion in 'Pickups & Electronics [BG]' started by JIO, Mar 14, 2013.

  1. JIO

    JIO Gold Supporting Member Commercial User

    Jun 30, 2010
    Oceana (Pacifica) CA
    musician/artist/owner - Gildaxe
    I thought I found what I was looking for but I still need help. I have a 3 pole/3 position rotary switch. I marked w/dots where the stops are. (1 dot/2 dots/3 dots - 3 locations) I'm going to assume that the center poles align w/the set between 1/2 for each. Maybe that's not true, so correct me if I'm wrong.

    I want to wire it for 2 (passive) pu's, N/N&B/B - a basic set-up. I'm not versed in reading technical drawings so would need pretty simple wire A goes from here to here, or a simple sketch.

    Before posting this I searched extensively for a tutorial or schematic that would answer my question but I just can't find anything. It's not even that tricky - just 3 positions. :help:


    I found this EB-3 cavity shot but it's hard to determine exact configuration from it, otherwise it's basically what I'm after.
  2. 6141689692_eff07359a3_o.

Share This Page