1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

400+ output jacks?

Discussion in 'Amps and Cabs [BG]' started by Rockbobmel, Oct 19, 2002.


  1. Rockbobmel

    Rockbobmel Supporting Member

    Just got my 400+ yesterday. This thing sounds much better to me than my SVT did. It seems to be much tighter too. Maybe couse the master vol.

    Anyway, I am a little confused with the speaker output jacks. There are 2+1 above on the 4 ohm side, and same for 8 ohm side. I used 2 8 ohm cabs and daisy'd them into one of the 4 ohm jacks and it worked fine. But is the top one for 2x4ohm dais cabs for a 2 load? If so, is the upper on the 8ohm side for 2x8ohm for a 4 ohm load?

    Are the bottom jacks for running 2 single cabs that are equipped with only 1 jack?

    I just want to make sure that I don't screw anything up.

    Thanks, Bob.
     
  2. boogiebass

    boogiebass

    Aug 16, 2000
    If you run a single 8 ohm cab, plug it into one of the 8ohm jacks. If you run two 8 ohm cabs, plug them both into the 4 ohm jacks. And so forth. The total load determines where you plug them in.