1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
    TalkBass.com has been uniting the low end since 1998.  Join us! :)


Discussion in 'Amps and Cabs [BG]' started by Bigunslinger, Jun 11, 2001.

  1. I've been thinking (Which is bad if you really know me) about making my own
    4x12 speaker cab but I have no Idea Hiw I would Wire the Thing

  2. A pair of 2x12 is a LOT easier to haul around, and sounds identical if built correctly.

    You can parallel the 8-ohm drivers in each cab, then series the two cabs to get back to 8 ohms total load.
  3. Munjibunga

    Munjibunga Total Hyper-Elite Member Gold Supporting Member

    May 6, 2000
    San Diego (when not at Groom Lake)
    Independent Contractor to Bass San Diego
    It would be easier to put the (8-ohm) speakers within each cab in series, then parallel the cabs to get back to 8. Or you could put 16-ohm speakers in parallel in each cab, then parallel the cabs to get to 4 ohms.

Share This Page