1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

8mm pot shafts in 3/8" control plate holes?

Discussion in 'Pickups & Electronics [BG]' started by ko stradivarius, Aug 2, 2007.


  1. ko stradivarius

    ko stradivarius

    Aug 14, 2006
    St. Louis
    I just picked up an HAS jazz harness which has all 8mm split shaft pots on it. (I have the brass collars for the solid shaft knobs).
    I just wanted to see if I'll need any kind of spacers or collars for the 3/8" holes in the control plate before I start installing it.
    From the lack of info from searching I assume I'll be fine but want to be sure.

    Thanks.
     
  2. Jo6Pak

    Jo6Pak

    May 2, 2007
    I've never heard of 8mm pot shafts, only 6mm and 1/4". Thanks for the heads up on that...
     
  3. m.oreilly

    m.oreilly

    Jul 5, 2006
    Ukiah, CA
    i do it all the time. you should have no problems.
     
  4. ko stradivarius

    ko stradivarius

    Aug 14, 2006
    St. Louis
    Thanks. Like I said, just wanted to be sure. Once I get started I dont want to stop the installastion until I can play it. :)
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.