1. Please take 30 seconds to register your free account to post, make friends, earn reward points at our store, remove most ads and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

A little help with Ser/Par switching....

Discussion in 'Pickups & Electronics [BG]' started by ElBajista, Feb 24, 2006.


  1. ElBajista

    ElBajista

    Dec 13, 2005
    Sebring, FL
    So I finally got everything I need to mod my SX: Shielding Tape, Pickups, Wire, Soldering Iron, Pots, mini-switch, etc.

    I was really excited to finally get around to doing this, but then I notice a major problem:

    I notice that the schematic I planned to use (below) shows the mini-toggle as having 9 prongs on the bottom, and the mini-toggle I bought from StewMac only has 6. The Schematic:

    [​IMG]

    The toggle switch: [​IMG]

    Anyone have a schematic for a bass in V/B/T with a mini-toggle having 6 prongs? If not, is there any other way that I can fix this without having to order and wait for another part?

    Thanks in advance.
     
  2. ElBajista

    ElBajista

    Dec 13, 2005
    Sebring, FL
    So, I can use the same wiring pattern on my mini-toggle that's shown in that schematic to be on the switch part of the push/pull pot?

    Thanks!