1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

A little rewiring help please (blend pot).

Discussion in 'Pickups & Electronics [BG]' started by MBIYF, May 29, 2005.

  1. MBIYF


    Oct 6, 2004
    The Netherlands
    Blessed Sunday you all!

    I could use a little help. I have a PJ with a PU switch. I hate switches so I bought a blend pot. I've been soldering all afternoon. But it's not working how it should. I got the P and the J working in the extreme positions, but moving towards the middle position doesn't blend the signals, the volume goes to 0. :meh:

    What did I do wrong?

    This is the blend pot:

    Dual 500K Blend/Balance Audio Taper Pot, With Center Detent, With Hardware


    I hooked it up exactly like this:

    Link to schematic in PDF format

    Thanks in advance! :cool:
  2. Alowishus


    Feb 28, 2005
    If you have a multimeter, you can test the pot to see if it works. All I can realy offer you is lyle caldwell's diagram of a blend-volume-tone setup. Ive used one of lyle's diagrams before and they're good.

  3. MBIYF


    Oct 6, 2004
    The Netherlands
    The multimeter trick worked.
    Dang, I could have figured that out myself. Thanks Alowishus.

    Great! :)

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.