A Quick Q on Stacked knobs...

Discussion in 'Pickups & Electronics [BG]' started by canopener, Jan 4, 2005.


  1. canopener

    canopener

    Sep 15, 2003
    Isle of Lucy
    I've been fiddling with the idea of rewiring my jazz to a stacked vol/tone, vol/tone configuration. I've experimented with the series/parallel mod, and I think I'm going to try this next. But my question is, on the dual concentric pots, am I correct to assume that the top and bottom set of pins corresponds to its respective knob? Does each pin (in the row of three) serve a particular purpose, or would I be correct to follow the run of the mill jazz bass p-up wiring diagram and adjust accordingly for the stacked knobs? I think I've read every thread on this 10 times over, but couldn't quite answer these two questions.
    Thanks
     
  2. xyllion

    xyllion Supporting Member Commercial User

    Jan 14, 2003
    San Jose, CA, USA
    Owner, Looperlative Audio Products
    Yes, each row of three lugs is the same as a row of three lugs on a single pot. Wire each volume/tone combination as if it were a P bass and then tie the two outputs together at the jack.
     
  3. canopener

    canopener

    Sep 15, 2003
    Isle of Lucy
    Cool, thanks!
     
  4. Primary

    Primary TB Assistant

    Here are some related products that TB members are talking about. Clicking on a product will take you to TB’s partner, Primary, where you can find links to TB discussions about these products.

     
    Jul 25, 2021

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.