1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

Amp / Cab configuration?

Discussion in 'Amps and Cabs [BG]' started by ehinkley, Aug 17, 2007.


  1. ehinkley

    ehinkley Supporting Member

    Aug 13, 2007
    Orlando, FL
    Since I've always been a combo guy and this is my first experience with an amp/cab setup, am I understanding correctly that if you come out of your amp into an 8 ohm cab, then out of that cab into another 8 ohm cab that you now have a 4 ohm load?
     
  2. chrisx666

    chrisx666

    Oct 15, 2006
    Yorkshire UK
    Yep, if all the cabs are wired as per normal convention (connectors wired in parallel).
    You would get the same result running two individual cables to each cab from the two outputs on the amp (mono amps usually have two outputs, wired in parallel).
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.