1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

Ampeg 8X10 Classic

Discussion in 'Amps and Cabs [BG]' started by Razor, Jul 20, 2005.

  1. Razor


    Sep 22, 2002
    Wondering if anyone has the PDF user's guide for the Ampeg Classic 8X10. Ampeg took it off the site and I'm trying to locate one.

    This is one of the new Classic cab's with the Speakon connections on the back.

    One 1/4" jack at the top that says top 4x10

    Two 1/4" jacks under that for mono mode

    Two speakon's under that which I assume is mono mode.

    Does anyone, who has this cab, run their's stereo? If so...where do the two 1/4" connections go.... since I don't have the manual I'm just trying to be sure before I throw a lot of power through the cab.
  2. Send me your email and I'll send it to you as an attachment.
  3. I run one channel into the top 1/4" input and the other into the lower speakon connection.
  4. Razor


    Sep 22, 2002
    Thanks very much guys!!

    Sent you an email Eric....thanks again!

  5. Jerrold Tiers

    Jerrold Tiers

    Nov 14, 2003
    St Louis
    I have PDFs for 4 types of 810, so if you give the model number and email, I can get it to you if the other source doesn't pan out.

    It should probably be either an SVT810E or SVT810 AV.

    But PR810H also has that setup.
  6. Razor


    Sep 22, 2002
    I don't know what the model number is...won't see the cab for a week or so. I can tell you it's the basic 8X10 and it has the "Classic" badge down at the bottom corner.

    I dunno if that helps, but it's the most basic version of Ampeg's 8x10 equipped with both speakons and 1/4" inputs.
  7. Is it the basic black front? if it is its probably the 810E