1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

Ampeg svt 4 pro best way to connect to cab

Discussion in 'Amps and Cabs [BG]' started by jmehlhouse, Jul 24, 2012.


  1. jmehlhouse

    jmehlhouse

    Dec 11, 2011
    What is the best way to connect this to a single ampeg 810 cab, I want it to be as loud as it can but not risk damaging speakers.
     
  2. JimmyM

    JimmyM

    Apr 11, 2005
    Apopka, FL
    Endorsing: Ampeg Amps, EMG Pickups
    The most wattage would be mono bridged at 4 ohms, but running each half into each side at 8 ohms should be plenty earsplitting enough for most people. You can run it either way as long as you use common sense, and remember that if it sounds like the cab's going to explode, it will.
     
  3. I use a speaker cable.
     
  4. But you have to use a $150 Monster Pro speaker cable. :) (Note the smiley, that is a joke.)
     

Share This Page