1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

Ampeg svt200t into 1X15 and 2X10 simultaneously

Discussion in 'Amps and Cabs [BG]' started by sioux, Aug 14, 2007.


  1. sioux

    sioux

    Dec 18, 2006
    Moscow, Russia
    I have svt 200t head and i can buy SVT15ED svt12HE and SVT210HED cabs.
    I'd like to get 15 and 210 to connect them parralel to 200t output.
    Should it be correct, 200 watt amp into 4 ohms?
    Thank you.
     
  2. davelowell2

    davelowell2 Uhh... FaFaFooey is BaBaBooey... Supporting Member

    Apr 20, 2006
    NYC via StL
    I have that amp and it will be 350 or 320 at 4 ohms. You should be getting a good amount of volume with that combo.
     
  3. John Wentzien

    John Wentzien

    Jun 25, 2007
    Elberta, AL
    Artist:TC Electronic RH450 bass system (original test-pilot)
    I think it would sound very good.
     
  4. sioux

    sioux

    Dec 18, 2006
    Moscow, Russia
    "I have that amp and it will be 350 or 320 at 4 ohms..."

    350 or 320 - you mean Watt?
     
  5. anderbass

    anderbass

    Dec 20, 2005
    Phoenix. Az.
    Your amp is 200W @ 8 Ohm, or 350W with a 4 Ohm speaker load.
    So using two 8 ohm cabs will give your amp its full 350 watt output.
     
  6. davelowell2

    davelowell2 Uhh... FaFaFooey is BaBaBooey... Supporting Member

    Apr 20, 2006
    NYC via StL
    Yes, watts, sorry.
     
  7. sioux

    sioux

    Dec 18, 2006
    Moscow, Russia
    Yes, Thanks, I expect of something like this. But, are you sure that such load is quite safe for the amp? Davelowell2, did you try 8 Ohm on your 200t?
     
  8. davelowell2

    davelowell2 Uhh... FaFaFooey is BaBaBooey... Supporting Member

    Apr 20, 2006
    NYC via StL
    Yes, 8 ohm is safe.
     

Share This Page