1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

B212: About to put castors on...

Discussion in 'Amps and Cabs [BG]' started by metalbass101, Mar 1, 2005.


  1. metalbass101

    metalbass101

    Jan 24, 2004
    I know how to and all I have the screw gun and 16 1" screws, and a ruler. I have a few ?'s though.




    1. Should I put them on the sides or infront/behind the corners?

    2. When I play I get a ton on shaking in the whole house, it gets to the point where I hear the rumbling of the contents in/out of the room more that my actuall sound sometimes, will castors elimate some of this by chance?

    3. Any thing I should know?
     
  2. Eric Moesle

    Eric Moesle

    Sep 21, 2001
    Columbus OH
    For stability, place them as near to the corners as you can, but stay back a little bit for structural integrety of the cab, you don't want to drill right at the edge or have the pressure from being dropped on the wheels to be born by a weak edge of the cab.

    Also, verify BEFORE drilling that you have sufficient space so that neither your drill nor your screws will hit a speaker or other component inside the cab.

    Your speaker will still sonically couple with the floor through the wheels, just perhaps not quite as much due to the vobration absorption qualities of the rubber wheels. The softer the rubber, the more absorption of vibrations.