1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

SOLD Crown XLS 602 1200w

Discussion in 'For Sale: Amps, Preamps, and Cabinets' started by ModulusQ5-122, Jul 2, 2012.


Thread Status:
Not open for further replies.
  1. It was always kept in a rack, is in good shape and works great. $175 shipped!!

    Here are the specs from crown.

    The following applies to units in Stereo mode with 8-ohm loads unless otherwise specified.

    Performance
    380W @ 8 ohms stereo
    600W @ 4 ohms stereo
    1200W @ 8 ohms bridged

    Sensitivity (volts RMS) for full rated power at 4 ohms: 1.25 V.

    Frequency Response (at 1 watt) 22 Hz to 20 kHz: +0 dB, 0.8 dB.

    Signal-to-Noise Ratio (20 Hz to 20 kHz)
    A-weighted, below rated power:
    >98 dB.
    No weighting, below rated power:
    >93 dB.

    Total Harmonic Distortion (THD): <0.5%.

    Intermodulation Distortion (IMD):
    (60 Hz and 7 kHz at 4:1) from full rated output to +40 dB: < 0.3%.

    Damping Factor (8 ohm) 10 Hz to 400 Hz: >200.

    Crosstalk (below rated power)
    at 1 kHz: +76 dB. at 20 kHz: +58 dB.

    Input Impedance (nominal): 20 kilohms balanced, 10 kilohms unbalanced.

    Load Impedance: Rated for 2 to 8 ohms per channel in Stereo, 4 to 8 ohms in Bridge Mono.

    The following applies to units in Stereo mode with 8-ohm loads and rated input sensitivity unless otherwise specified.

    Sensitivity (volts RMS) for full rated power at 4 ohms: 1.025

    Frequency Response (at 1 watt) 20 Hz to 20 kHz: Sensitivity (volts RMS) for full rated power at 4 ohms: 1.25

    Frequency Response (at 1 watt, 22 Hz - 20 kHz): +0 dB, -1 dB

    Signal to Noise Ratio below rated power (20 Hz to 20 kHz, inputs terminated)

    A-weighted, below rated power: > 100 dB

    No weighting, below rated power: > 95 dB

    Total Harmonic Distortion (THD) at 1 full bandwidth power, from 20 Hz to 1 kHz:
    < 0.5%

    Intermodulation Distortion (IMD) 60 Hz and 7 kHz at 4:1, from full rated output to -30 dB: < 0.3%

    Damping Factor (8 ohm): 10 Hz to 400 Hz: > 200
    Crosstalk (below rated power):
    - at 1 kHz: -75 dB
    - at 20 kHz: -50 dB

    Input Impedance (nominal) (balanced, unbalanced): 20 kilohms, 10 kilohms

    Load impedance
    - Stereo: 4-8 ohms
    - Bridge mono: 8 ohms

    AC Line Voltage and Frequency Configurations Available (+/- 10%):
    - 120 VAC 60 Hz
    - 100 VAC 50/60 Hz
    - 220 VAC 50 Hz
    - 230-240 VAC 50 Hz

    Ventilation: Flow-through ventilation from front to back

    Cooling: Internal heat sinks with forced-air cooling

    Air Volume Requirements (per minute per unit): 80.15 ft3 (2.27 m3)

    Dimensions: Width, Height, Depth
    - XLS 202, 402, 602, 802: EIA Standard 19"W (EIA RS-310-B) x 3.5" (8.9 cm) H x15.2" (38.6cm) D.
    - XLS 5000: EIA Standard 19"W (EIA RS-310-B), 5.25" ( 13.3 cm) H x 15.5" (39.5 cm) D.

    Net Weight, Shipping Weight:
    - XLS 202: 23.0 lb (10.4 kg)
    - XLS 402: 25.7 lb (11.7 kg)
    - XLS 602: 29.0 lb (13.2 kg)
    - XLS 802: 35.5 lb (16.1 kg)
    - XLS 5000: 62.0 lb (27.7 kg)



    image-3297456834.
     
  2. Still available.

    Also taking trades on 5 string jazz pups or jazz preamps. Would also consider lower end 5 string jazz basses.
     
  3. Price drop $175 shipped
     
  4. Bump
     
  5. Bump
     
  6. Bump
     
  7. dbsfgyd1

    dbsfgyd1

    Jun 11, 2012
    Richmond , Va
    Mod,

    Would you consider taking a Fender Squire Precision 5 string on trade? Even though it's a P bass body, the pickups are Jazz pickups. Please advise on a PM. Thanks.
     
  8. Pmed
     
  9. Sold on eBay. Closing thread.
     

Thread Status:
Not open for further replies.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.