1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

CS800S Bridge Mode Confusion

Discussion in 'Amps and Cabs [BG]' started by Larry Close, Aug 23, 2016.


Tags:
  1. Larry Close

    Larry Close

    Aug 23, 2016
    Just built a rack with a CS800S with the S1 module installed from Craigslist. First time dealing with this kind of setup. I have it going into 2 4x10 cabs but it's not anywhere near the loudness it should be. I know I don't have it hooked up correctly and have not found any info that really makes sense to me. Just curious what cords I need and where they go to get the max out of this amp. I've included a pic of the back of the amp.
     
  2. agedhorse

    agedhorse Supporting Member Commercial User

    Feb 12, 2006
    Davis, CA (USA)
    Development Engineer-Mesa, Product Support-Genz Benz
    You need the owner's manual because you need to set the output jack module jumpers for bridged operation. Otherwise you are only connecting to a single channel with the jumpers in the default mode.
     

Share This Page