1. Please take 30 seconds to register your free account to post, make friends, earn reward points at our store, remove most ads and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

custom 60's jazz bass p/u

Discussion in 'Pickups & Electronics [BG]' started by Mind Eroded, Jan 3, 2006.


  1. Mind Eroded

    Mind Eroded Supporting Member

    Apr 25, 2003
    Brooklyn/Buffalo, NY
    I was looking at the specs for the fender custom 60's shop pickups and was wondering if anyone knows if the two are the same size at the bridge and neck or different. I wanna put em in my SX and wanna know if they would fit.
     
  2. Indiana Mike

    Indiana Mike

    Nov 18, 2005
    I have these, let me measure them and I will post back.
    They are killer pickups for more of a vintage tone.
     
  3. Indiana Mike

    Indiana Mike

    Nov 18, 2005
    Neck pickup appears to be 3 37/64ths
    Bridge " " " " 3 23/32nds (46/64ths)
    The bridge pickup is a little longer than the neck.
    when I put these in my MIM jazz I had to route the pickup cavity under the pickup, not the body, to make room for the wires.
    The bridge is about 9/64ths longer .
    Measurements may vary by a couple of 64ths as I used a steel machinists rule and my eyes but are very close.
     
  4. Mind Eroded

    Mind Eroded Supporting Member

    Apr 25, 2003
    Brooklyn/Buffalo, NY
    thanks alot dude.
     
  5. Indiana Mike

    Indiana Mike

    Nov 18, 2005
    No problem.
    I did fail to say that the neck pickup fit just fine, the bridge (I know what I already said above) was a very tight squeeze in the hole lenghtwise but it did JUST fit.