1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

Daisy chain 16ohm into 8ohm cab

Discussion in 'Amps and Cabs [BG]' started by kickinbass, Dec 10, 2006.


  1. kickinbass

    kickinbass

    Nov 19, 2004
    ontario canada
    Ok so i have a BX3000T 300 watt bass head. two individual outputs. rated at 8ohms max 4ohm min. My cabs are a yorkville 115B 300 watt 8 ohm and a Peavey 210TX 4 ohm wired in series to 16 ohms 300 watt. According to science it gives me 5.333 ohms total and my amp should be fine. two questions first. should i connect the 115B to one output jack and the 210TX to the other output jack running parallel or run the 210TX with 16ohm rating into the 115B with a 8ohm rating then connect a single cable from the 115B to the amp head? question 2 is if i run them into each output what is the watt ratio for each cab since the ohms rating is different. And if i run one into the other with a single connection to the head would the powering rating only read a 5.333 ohms cab instead of two seperate. thanks guys for all the help. Billy aka kickinbass
     
  2. anderbass

    anderbass

    Dec 20, 2005
    Phoenix. Az.
    I'd try it in every possible hookup method, and see what sounds best.
     

Share This Page