1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

Dead preamp

Discussion in 'Pickups & Electronics [BG]' started by Tubakid09, Feb 26, 2008.


  1. Tubakid09

    Tubakid09

    Jan 25, 2008
    I'm looking to get a new Bart preamp as you may have seen, but I'm also trying to see what the cause of death for my current is.

    I was trying to tighten output jack and knobs, I tightened them as best I could, but for the jack, I had to use pliers to hold the inside part of it while I turned with a combo wrench. I didn't take the battery out before I did this; could the small voltage running through the preamp have caused a short when the pliers touched the circuits and ground connected to the jack? If not, what else could kill a preamp through tightening of pot knobs and jack?
     
  2. Tubakid09

    Tubakid09

    Jan 25, 2008
    For the record, the bass still puts out sound, but it is quiet and completely unchangeable by any knobs.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.