PRICE DROP TO $425 SHIPPED OBO!!! Doubleneck by jposega, on Flickr Doubleneck by jposega, on Flickr Doubleneck by jposega, on Flickr Doubleneck by jposega, on Flickr Double neck by jposega, on Flickr Doubleneck by jposega, on Flickr This instrument plays and sounds good, but it has a number of quirks. First, whoever made it didn't line anything up. You can see in the pics how off the pickup routes are from the neck centerline. I'm pretty sure that's why it's got Schaller roller bridges on both sides. EMG Hz pickups on both sides; they sound OK on the bass, but I really like how the guitar sounds. More Strat like than most hum buckers. There's a volume, tone, and 3-way switch for each neck, and then a 3 way switch to turn on either neck or both (there are two outputs, it is NOT wired so both necks can go through one). The original neck (which I presume was made or fretted by the builder) had a stupid low first fret. That's why you're seeing copper shielding tape on that extra neck. I got a Squier CV 60's P neck on the bass side right now, which is much better than the original. I had to sand the neck pocket a bit to get the Squier neck to fit. There is some general finish wear and flaking there, and in a couple other places. Obviously, it's heavy. Probably around 15 lbs. Buyer will get the double-neck with the Squier neck installed (I'll put the top strap button back on, I had a strap lock there but needed it on a different bass) plus the original neck. Where else are you gonna get a non-eBay-Chinese-Special double neck for $425 shipped? CONUS only, no trades, make an offer.