Dumb J pickup / Audere question

Discussion in 'Pickups & Electronics [BG]' started by vivaknoxvegas, Nov 17, 2016.


  1. vivaknoxvegas

    vivaknoxvegas El Duderino Gold Supporting Member

    May 6, 2002
    Knoxville, TN
    I have a jazz with an Audere pre in it, the JZ3. If I want to change the pickups, can I just cut out the old pickups at the pickup cavity, and then tie the new pickups into the existing wires coming from the control cavity?

    If I don't have to, I don't want to mess with anything related to the pre because there's almost no room in there.
     
  2. vivaknoxvegas

    vivaknoxvegas El Duderino Gold Supporting Member

    May 6, 2002
    Knoxville, TN
    Anyone?
     
  3. 40Hz

    40Hz Supporting Member

    May 24, 2006
    home
    You could. But with leads cut too short you've pretty much destroyed the resale value of the pickups. And you'd still need to solder the leads and either shrinkwrap or tape the joins. Easier to just unscrew the leads at the preamp IMO.
     
  4. Primary

    Primary TB Assistant

    Here are some related products that TB members are talking about. Clicking on a product will take you to TB’s partner, Primary, where you can find links to TB discussions about these products.

     
    May 21, 2022

Share This Page