1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

Eden d210t and Ampeg/Connection question

Discussion in 'Amps and Cabs [BG]' started by btrag, Oct 12, 2010.


  1. btrag

    btrag

    Mar 7, 2005
    Chicago
    I am using an Ampeg SVT-400t (200w into a 4 ohm load) with an Eden d-210t 10x2 4ohm cabinet. How should I connect these two?
    The Ampeg has five-way binding posts and the Eden cabinet has one 1/4 jack.

    Which output terminals should I use? Should I bridge the amp? Or, should I run it in "slave mode"? I am new to this, as you can probably guess.
     
  2. INTP

    INTP

    Nov 28, 2003
    Dallas, TX
    http://www.ampeg.com/pdf/SVT400T.pdf

    According to this manual, the amp has either 1/4" jacks or banana plug/binding posts. You can either use a 1/4" to 1/4" speaker cable, or else one with banana plugs on one end and 1/4" plug on the other.

    The manual also states that in bridge mode, the impedance should be 8 Ohms or greater. Based on that, bridge mode isn't recommended for this cabinet. Run it instead in "slave mode" and just use one amp channel for this speaker cabinet.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.