1. Please take 30 seconds to register your free account to post, make friends, earn reward points at our store, remove most ads and more!  
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

Eden - EC1060XL 4 ohm speakers

Discussion in 'Amps and Cabs [BG]' started by DavidEdenAria, Dec 24, 2013.

  1. DavidEdenAria


    Dec 13, 2013
    On a Hill
    I own an Eden 'the metro' 2x10 combo amp made in Minnesota.

    It says "600 watts into 2 ohms" on the amp chassis.

    So I decided to pull the speakers loose to check connections and sure enough, these speakers are dated 2 years newer.

    On top of that, each speaker has one push on connector that is making contact but the OTHER wire is just loosely hanging on each speaker!

    I'm going to go ahead and cold crimp and then solder the connections.

    Are these the right replacement speakers for this amp?

    They are Eden brand built in 2006 and are newer than the amp so I know these are replacements with the crappy dangling twisted wire.

    Anyone else use these or others in 2x10 Eden's?