1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

EDEN Rig Question

Discussion in 'Amps and Cabs [BG]' started by FunkBass535, Aug 29, 2003.

  1. FunkBass535


    Aug 29, 2003
    Looking at putting a rig together with a Navigator Pre Wt 1000 power amp and 2 210XLT 8 ohm cabs can it be done with out blowing the amp or cabs and should it be run in bridge or each cab on its own channel. any help would be great

  2. Munjibunga

    Munjibunga Total Hyper-Elite Member Gold Supporting Member

    May 6, 2000
    San Diego (when not at Groom Lake)
    Independent Contractor to Bass San Diego
    It can be done. If you run one side to each speaker, you'll get about 300 watts a side. That'd be just peachy. If you bridge it into the two speakers in parallel (daisy-chained), all 1,000 watts will be available. The speakers would be able to handle 700 watts of that, so be careful, just don't crank it all the way up. With that setup, your tone will be superb, but it won't be exceptionally loud. Just remember, in bridged mono, you will have more volume knob than you can put into the speakers.

    It'll work either way, and it'll sound great.