1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

Effects go where in the chain?

Discussion in 'Effects [BG]' started by FrolicHoek, Feb 13, 2002.

  1. FrolicHoek


    Nov 14, 2001
    Dallas, TX
    I am about to start using a digitech multieffects processor in my signal chain, but I wanted to know where the best place to put it is. I am stricly going to use the compressor and that is it. No other effects. My other gear is a Peavey T-Max head and a sonic maximizer (mono). Where should I put the compressor in the chain? Before or after the maximizer? Thanks for your help!
  2. Chasarms

    Chasarms Casual Observer

    May 24, 2001
    Bettendorf, IA USA
    Run the compressor, then the maximizer through the effects loop of the amp.

    I played around with a BBE for a while. IME, it has to be the last link in the chain or its effect is lost.

  3. yawnsie


    Apr 11, 2000
    Err... bit of a grey area, but I think this might get a better response in Effects. If you disagree Bigfeet, send it back this way.
  4. Yup right forum.

Share This Page