Dismiss Notice

Psst... Ready to join TalkBass and start posting, make new friends, sell your gear, and more?  Register your free account in 30 seconds.

FS: Hamer Cruise 5 string USA 2-Tek

Discussion in '[OLD FORUM] Bass Guitars, Amps, and Accessories: F' started by David Wilson, Jan 26, 2005.


  1. David Wilson

    David Wilson Administrator Staff Member Administrator Supporting Member

    Oct 14, 2002
    Lower Westchester, NY
    This is a US made Hamer Cruise Bass, serial number 543478.

    Smooth jazz style neck w/ rosewood board, 2 TEK through body bridge. Seymour Duncan basslines pickups, Seymour Duncan 2 band preamp. Controls are master volume (with push/pull for slap contour eq), blend, stacked bass/treble.

    Bass is in overall excellent condition, 3-4 pencil tip sized bumps but they were too small to get a good photo of. None of them break the finish, and are only visible from extremely close up. Some standard mild scratching, what you'd expect and again nothing breaking the surface or visible from beyond a few inches away.

    Comes with original Hamer Case.

    I'd like $575 shipped obo in lower 48. NO TRADES. So, please no "I know you said no trades, but..." messages

    More photos at:
    http://home.earthlink.net/~davidmwilson/hamer/
     

    Attached Files:

  2. Jugghaid

    Jugghaid

    Jun 28, 2002
    Denver, CO, USA
    Hey David,

    What's the string spacing on these....17mm?
     
  3. David Wilson

    David Wilson Administrator Staff Member Administrator Supporting Member

    Oct 14, 2002
    Lower Westchester, NY
    I'll take an exact measurement tonight, it's either 18 or 17mm. Definitely not 19
     
  4. Jugghaid

    Jugghaid

    Jun 28, 2002
    Denver, CO, USA
    Cool.
     
  5. Juggy, you should buy this and then sell it to me later down the road. You know it's gonna go that way :D
     
  6. Jugghaid

    Jugghaid

    Jun 28, 2002
    Denver, CO, USA
    :D Saw you traded off the ATK.
     
  7. Brendan

    Brendan

    Jun 18, 2000
    Austin, TX
    Dave, how wide is it at the nut? 45mm/1.75"? (I'm hoping for wider, but I'm not very optimistic about it.)
     
  8. David Wilson

    David Wilson Administrator Staff Member Administrator Supporting Member

    Oct 14, 2002
    Lower Westchester, NY
    I'll measure tonight
     
  9. David Wilson

    David Wilson Administrator Staff Member Administrator Supporting Member

    Oct 14, 2002
    Lower Westchester, NY
    sold to soulbrother!