1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

Hartke LH1000 speakon connector wiring

Discussion in 'Amps and Cabs [BG]' started by murphy963, Apr 2, 2009.


  1. murphy963

    murphy963

    Apr 2, 2009
    Hi, I have a Hartke lh 1000 amp and I run a vx115 and a vx410 on each channel. I wish to wire it in a bridged mono mode by using the speakon . Can any one tell me how to wire the speakon to jack in a way that i can operate it as a single bridged channel? What terminals of the speakon male shall I use? my intention is to connect only one cabinet or the two in series. I tried several configurations but to no avail.:rollno:
    Thanks
    murphy963
     
  2. NorCal Dog

    NorCal Dog

    Nov 28, 2005
    415/707
    if you're running speakon to speakon, it's normally 1+ to 1+ & 1- to 1-

    BUT ALWAYS

    check out what your cab manufacturer recommends
     

Share This Page