1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

Help w/ Eden Navigator set-up

Discussion in 'Amps and Cabs [BG]' started by LowfreqB, Jun 22, 2001.

  1. LowfreqB


    Nov 10, 2000
    United States
    Hey everyone, I just got a Eden pre-amp, I previously owned a SWR 350. So this pre-amp/power-amp set up is new and confusing to me.

    Okay here's my question. The Eden has 2 outputs Left and Right for High and Low sounds. I want to run the whole set up in mono at 8ohms (mackie 1400i) I looks like I have to run both channels. or leave out either High the Low channel.

    Can you tell me how you set up your rig?
  2. mikezimmerman

    mikezimmerman Supporting Member

    Apr 29, 2001
    Omaha, Nebraska
    I had a Navigator that I ran through a Mackie in bridged mono. You just put the preamp in "Stereo" mode rather than "Bi-amp" mode (so there's not crossover in the circuit, and no "High" or "Low"--both sides have the same signal), then pick either the left or right channel to go out to the power amp.

  3. LowfreqB


    Nov 10, 2000
    United States
    thanks much :)

Share This Page