1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

Help with hooking up Eden WT 400

Discussion in 'Amps and Cabs [BG]' started by AndyMan, Mar 1, 2004.

  1. AndyMan

    AndyMan Supporting Member Commercial User

    Jun 17, 2000
    Columbus, Ohio
    Hey everyone--

    I want to use my WT 400 with another power amp.

    Here's the scenario:

    I plan on racking the WT400 in the same rack as a Carvin power amp (DCM 600). I'll use the WT400 speaker out to an Ampeg Portabass 1x12 cab puting out 400 watts @ 4 ohms into that cab.

    Then I want to take the post eq line out of the WT 400 to the Carvin putting 450 seperate watts out from the Carvin into an Ampeg 410 HE Classic cab.

    Will this work?

    Also, is there a way to go direct to the PA board at the same time? I.e., is there a cheap signal splitting box I can get to use for the line out of the WT400, sending one signal (post eq) to the Carvin and another (post eq) to the PA board????


  2. quallabone


    Aug 2, 2003
    That setup should work just fine. You can run to the PA by using the Balanced XLR output on the back of the Eden.


Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.