1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

hi guys need help.

Discussion in 'Luthier's Corner' started by 0175westwood29, Jan 5, 2008.

  1. 0175westwood29


    Sep 16, 2007
    im thinking of moving the input jack on my axl 5er as im in the middle of modding it to look like an sr5.

    and i was looking into getting a new jack as it will need a longer barrel to get to the control cavity than just fixed to a plate with the pots.

    anyone know where i can find a site or know wat jack is in the sr5's?

    here are some pics
  2. 0175westwood29


    Sep 16, 2007
  3. 0175westwood29


    Sep 16, 2007
    just bout one thanks alot!
  4. 0175westwood29


    Sep 16, 2007
    new question i want a slide 3 posistion swtich? does it have to be a certain size?, and i need to know wat drill bit to use to drill from the pup cavity to the control one?
  5. Pini


    Dec 31, 2006
    The drill should be just large enough to run the few wires freely so they won't get snagged in there and strip the insulation of the wires. You could probably get a sliding 3 way at radio shack or a place similar. I haven't seen to many sliding ones (a tele selector switch would be another decent choice) so it may have to be special ordered. Size could vary, but it isn't too much trouble to cut the slot a little bigger to compensate. Best of luck.
  6. 0175westwood29


    Sep 16, 2007
  7. Primary

    Primary TB Assistant

    Here are some related products that TB members are talking about. Clicking on a product will take you to TB’s partner, Primary, where you can find links to TB discussions about these products.

    May 9, 2021

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.