1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

How to add a passive tone control...?

Discussion in 'Pickups & Electronics [BG]' started by rojo412, May 11, 2010.


  1. rojo412

    rojo412 Sit down, Danny... Supporting Member

    Feb 26, 2000
    Cleveland, OH.
    I looked, but didn't have a whole lot of luck...

    Just looking to add a PTC to an OBP-3 equipped setup. I have the bass set up for the bypass, but I wanted to wire the bass up so it had passive tone control in BOTH MODES.

    Anyone have a diagram or resource handy for such a feat? Figured I'd ask before attempting it.
     
  2. M0ses

    M0ses

    Sep 11, 2009
    Los Angeles
    It should work just fine if you connect the pot to the jack tip. And ground it, of course :D
     
  3. 3397526992_cbd9daaaa0_o.

    Just connect the "Input/Output" terminal to the output from the volume/blend pots.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.