1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

How would I go about doing this...

Discussion in 'Effects [BG]' started by Vosk, Apr 14, 2006.


  1. OK, so I'm going to get a few pedals this year.

    My system will ideally be:


    Bass clean signal (50%) --------> Amp
    Bass effected signal (50%)----^


    So how do I do this? I'll probably be running two distortions, a wah, Flanger and maybe a delay. Eventually. Anyway, do I have to buy a mini mixer or something?
     
  2. theres a blender that was posted on here a while ago. Not released yet, but i believe it was at NAMM, im sure some one will remember it and post a link. In fact, SMASH (i think) has the little pic from the diagram as his Avatar... or DID have it.

    Basically, run ur bass into it, then it has an output to your amp. It has send and return jack, and a large blend pot. Run all your effects in the loop, and use the blend pot to get 50% clean and 50% wet.... Or however it sounds best.

    Peace
     
  3. Thanks guys
     
  4. lug

    lug

    Feb 11, 2005
    League City, Tx
    Or, you could buy a Rickenbacker. It has a stereo out built in to the bass.
     

Share This Page