1. Please take 30 seconds to register your free account to post, make friends, earn reward points at our store, remove most ads and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

Inlay supply company - CNC capabilities

Discussion in 'Luthier's Corner' started by DSB1, Mar 17, 2006.


  1. DSB1

    DSB1

    Mar 8, 2006
    What I need is a supplier that can make my logo inlays with a CNC machine. The company that I used to use no longer can do it.

    Any recomendations/ideas?
     
  2. I could use the same info as well. I'm not sure where you are located but I'm in Colorado. Hopefully somebody has a good recommendation!
     
  3. Skorzen

    Skorzen

    Mar 15, 2002
    Springfield MA
    I bought some pearl from Masecraft a while ago and they mentioned being able to do that sort of thing. That was a little while ago, but I would assume they still can. I would give them a call or email or something. It was kinda funny actually when I was there they had invoices from Stewmac and Fender sitting on the counter. I had been debating just ordering the stuff from Stewmac when I found them :D