1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

Jarrah Custom P/ J Bass

Discussion in 'Luthier's Corner' started by needsmorecowbel, Oct 4, 2009.


  1. needsmorecowbel

    needsmorecowbel

    Oct 4, 2009
    Hi, I'm currently building a P / J style bass guitar from two pieces of Jarrah Timber (i know that is not ideal) (P style neck, J Style Body, J style Pickup configuration)

    What is the best way to get the wiring from the two J bass style pickup cavities to the tone and volume pot cavity? I was thinking of Drilling a hole with a drill at an angle? But the pickup cavities are very thin and hard to get a decent angle...Any constructive Suggestions/ Criticisms?

    Pictures of the Bass Body:

    http://img22.imageshack.us/img22/7103/dsc00110zz.jpg

    http://img89.imageshack.us/img89/9836/dsc00112pl.jpg

    (The Black Permanent marker on the wood is a rough guide-don't knock it- my last guitar was made using less measurements/ guides)

    Previous guitar:
    http://img9.imageshack.us/img9/9397/dscf2527b.jpg
     
  2. tdogg

    tdogg

    Jan 17, 2001
    Brooklyn Park, MN
  3. Rickett Customs

    Rickett Customs

    Jul 30, 2007
    Southern Maryland
    Luthier: Rickett Customs...........www.rickettcustomguitars.com
    Yessir, I have the 3 bit kit 1/4", 3/8" and 5/8". 2 builds so far, I have drilled the jack (side mount of course) just use the bit through the jack hole, to drill for the wiring.
     
  4. needsmorecowbel

    needsmorecowbel

    Oct 4, 2009
    Cheers dudes, really helpful advice. That first guitar only took 2 weeks. I Think the bass should only take about a week to build once i have all the parts and the neck.
     

Share This Page