1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

Jazz Bass Quarter Pound PUs w AB Mod pots in a pile :-)

Discussion in 'Pickups & Electronics [BG]' started by sparkyj, Mar 2, 2018.


  1. sparkyj

    sparkyj

    Mar 2, 2018
    Welp, Greetings to all. I hope one of you might be able to help me reconstruct this bucket of bolts. :)
    Years ago I took apart an old Jazz bass that was configured with 2 Quarter pounders and set up with 2 AB Mod push/pull pots along with a 500k tone pot. Over the years the mess has been separated from the wiring setup and I never wrote down the schematic for how this was wired. I think it might have been set up with a reverse phase possibility. I remember you were able to get a variety of tones.

    The wires have fallen off the pickups too. So I would like to know what the usual and customary way to reattach these colored wires is. Looks like 2 solder joints on one side and a single on the other.

    Also, based on what any of you see, do you think it is possible to figure out what the last guy had in mind for this set up? I would like to reinstall these pieces as they were.

    Are there any Push/Pull double volume control Jazz bass schematics out there? Been looking for a while but have not discovered any. Also tried to find a schematic of these AB pots just so I know what the internal setup is. They say "A-500k-OHM"

    Any help is appreciated! Check out these pics. Anyone recognize this PU brand?

    IMG_7922. IMG_7923. IMG_7925.
    IMG_7929. IMG_7928. IMG_7927. IMG_7926.
     

    Attached Files:


Share This Page