Progress this far of my semi lightweight 12” cab. I plan to build 2 of these and feed them 100 watts a piece.
I could have gone smaller, but wanted the extra height so I can hear it, especially when I stack two of them. Will be used for rehearsal and small bar gigs most likely.
Power will be either a BAM200 or Darkglass Microtubes 200.
Internal dimensions of 13” x 13” x 23”
Tuned to 45hz
Built from 1/2” birch plywood glued with construction adhesive and air stapled.
Fully Braced on all sides.
Port will be a 4” round port below the speaker.
Speaker is a MCM 55-2952 @ 8 ohm.
I could have gone smaller, but wanted the extra height so I can hear it, especially when I stack two of them. Will be used for rehearsal and small bar gigs most likely.
Power will be either a BAM200 or Darkglass Microtubes 200.
Internal dimensions of 13” x 13” x 23”
Tuned to 45hz
Built from 1/2” birch plywood glued with construction adhesive and air stapled.
Fully Braced on all sides.
Port will be a 4” round port below the speaker.
Speaker is a MCM 55-2952 @ 8 ohm.
