1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

Modding an HM4

Discussion in 'Hardware, Setup & Repair [BG]' started by Killdar, Dec 29, 2003.

  1. Killdar


    Dec 16, 2002
    Portland Maine
    I've been thinking about modding the electronics on my bass for a while but I need some ideas before I do anything. It's a Fender HM4, so it has 3 J pickups, a volume and tone pot, and a 5 way pickup selector switch. I might be able to fit another pot in there if I route some of the cavity away and drill another hole through the top (rear routed, no pg) but I'd rather not.

    One idea I had was to install a stacked pot for vol/tone and a blend pot or two for the pickups, then make the 5 way into a complicated series/paralell switch or something. Do stacked blend pots even exist? I could do without them but they'd help a lot.

    Any ideas?

Share This Page