1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

Neck fitting with a crap pocket.

Discussion in 'Hardware, Setup & Repair [BG]' started by Linas, Apr 12, 2006.


  1. Linas

    Linas

    Jan 6, 2005
    Chicago
    My SX project bass is nearing completion and when i go to fit the neck, its got some problems. For one before starting to mod the bass, there were a couple major dead spots, which might be attibuted to my shady neck pocket. The side to side fit is not bad, barely a gap, But there is a good 1/16" gap at the bottom of the pocket. Should i be concerned that the butt end of the neck isnt touching the body? What is the remedy?
    When bolted down the neck doesnt shift, but when not bolted, the neck shifts considerable, is this something i should be worried about?

    badpock4et.
     
  2. Volk

    Volk

    Dec 18, 2005
    South Jersey
    I don't think so, it shouldn't make any difference as long as it doesn't shift while bolted.
     

Share This Page