1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

New Ampeg

Discussion in 'Amps and Cabs [BG]' started by spalka621, Apr 23, 2006.


  1. spalka621

    spalka621

    Jul 26, 2005
    Minneapolis, MN
    I have a Ampeg B2R and I was wondering if there is any way to run two 4ohm cabs through it. I just not sure if running both creates a 2ohm load in the amp or two 4 ohm loads in both channels.
     
  2. hyperlitem

    hyperlitem Guest

    Jul 25, 2001
    Indianapolis, IN
    nope there isnt. Sell the 4 ohm cab for 2 8 ohm cabs or just push one.
     
  3. 8mmOD

    8mmOD

    Mar 20, 2005
    USA
    I endorse & use Tech 21 pedals, Eminence loaded cabs, EMG pickups, Jim Dunlop picks & Ernie Ball Strings, BC Rich Basses.
    The speaker outputs are wired in paralell so its the same as if you daisy chain the 2 cabs off of 1 output. 2 4ohm cabs = 2 ohm load. you could buy an inexpensive power amp, like a QSC RMX 850 (around $250) and use it to drive your second cab or change to 8 ohm cabs as mentioned.
     

Share This Page