1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

New P bass pickguard issue!

Discussion in 'Hardware, Setup & Repair [BG]' started by jenderfazz, May 5, 2006.


  1. I just bought a black P bass pickguard and the holes drilled for the tone and volume knobs is slightly smaller than the required size... thus, the pots don't fit in it! What can I do about it??
     
  2. [​IMG]

    Notice that the input jack is slightly larger than the volume and tone pot holes. I guess my P bass has large pots or something, but they don't fit into the smaller holes. Any ideas?
     
  3. fenderx55

    fenderx55

    Jan 15, 2005
    NYC/Queens
    make 'em bigger.
     
  4. 62bass

    62bass

    Apr 3, 2005
    Just get a round file of the proper size (a bit smaller than the hole already there) and ream it out. File in the direction of from top to bottm if you're concerned about a clean looking hole on the top. However, the washer on the pot will cover that up.

    It's no big deal. Just stop and check your work so you don't make the hole too large.
     

Share This Page