Polishing a Nitro Finish -- Scuffs under the bridge

Discussion in 'Hardware, Setup & Repair [BG]' started by Crazy Otto, Jan 27, 2016.

  1. Crazy Otto

    Crazy Otto

    Jan 11, 2016
    Germany
    Hello All,

    I picked up a Schaller bridge to replace the Fender Hi-Mass bridge that came on my bass. I noticed that when I removed the Fender bridge, there were some irregularities in places where the bridge came in direct contact with the finish (which is nitro). I'd like to get rid of these, since the new bridge is smaller than the Fender bridge -- what's the best way to go about doing this? Feedback appreciated!
     
  2. DiabolusInMusic

    DiabolusInMusic Functionless Art is Merely Tolerated Vandalism

    Just use automotive products to buff and polish. I use Meguir's stuff, like Scratch-X, but any quality stuff should work just fine.
     
  3. praisegig

    praisegig Gold Supporting Member

    Jul 7, 2008
    Stephenville, TX
    . Drop fill, level sand, polish is good advise
     
  4. Pilgrim

    Pilgrim Supporting Member

    Nitro is car paint, circa 1950. If it works on a car from that era, it works on nitro.