1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

Protecting the wiring...

Discussion in 'Pickups & Electronics [BG]' started by Eric Cameron, May 28, 2002.


  1. Hi guys. I just finished a bit of soldering on my project, and I noticed that two of the wires are VERY close together, and there really isn't anything that I can do about. But I was wondering if it would be feasible/safe to coat the wires and contacts in something non-conductive, like hot glue or epoxy? Or is this just a dumb idea?:D I juump around a bit on stage and I don't want a short from bouncing wires.

    Rock on
    Eric
     
  2. FalsehoodBass

    FalsehoodBass

    Jul 22, 2001
    Denver, CO
    electrical tape?

    for the future, or if you want to cut the wires and re-soilder, use a thin heat shrink tubing.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.