1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

Question For Stewart 1.2 Users

Discussion in 'Amps and Cabs [BG]' started by g4string, Mar 25, 2003.


  1. g4string

    g4string Supporting Member

    Sep 19, 2002
    Melissa, TX
    Two Part Question:

    Is the only way to hook your speakers to the 1.2 in a 4ohm bridged setup is by the bannan plugs. If so, I am planing on "daisy chaining" my cabinets together using the 1/4 ends and choping one 1/4 end of my speaker cable off and installing a bannana plug to hook up to the amp. Is this the correct way?

    If this is the correct way to hook up two 8ohm cabs to the 1.2 to bridge it into 4ohms, do I need to pay particular attention to the type of bannana plug I buy to install on my cable?:bassist:
     
  2. jokerjkny

    jokerjkny

    Jan 19, 2002
    NY / NJ / PHL
    you're pretty much on, and any banana clip will do. but pay attention to which ends of the banana clips go where on the amp's two red inserts.

    should be in the manual.