1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

Question regarding bridging a Crown XLS

Discussion in 'Amps and Cabs [BG]' started by LiquidMidnight, Nov 15, 2005.

  1. LiquidMidnight


    Dec 25, 2000
    Okay, I'm sure anyone who has experience with these amps knows about the brilliant engineering design that was concocted to make them bridgable (I was being sarcastic when I said "brilliant" :D ).

    Obviously, I need Y cable with two male XRL end, one end with reversed polarity. I also need the single end going to my preamp to be a 1/4. I'm not an electrician, so I have no idea how to make one of these (and I don't want to cause any damage by doing so). I was wondering if there was anywhere I could order these cables pre-made.

    Y cable
    2 XLR ends (one with reversed polarity)
    1 1/4 inch end

    I greatly appreciate any information anyone has. :)
  2. fretlessrock

    fretlessrock Supporting Member

    Aug 8, 2002
    I don't know of a commercial source, but I make them and so does Butch Ammons at Bayou Cables. http://bayoucables.com/