1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

quick tech question

Discussion in 'Amps and Cabs [BG]' started by loner9, Dec 12, 2011.


  1. loner9

    loner9

    Sep 18, 2010
    Plz correct me if i'm wrong here.

    I have a little mark 800.
    800 at 4 ohm, 500 at 8 ohm.

    It has two speaker outputs.

    If I hook up a single 8 ohm cab from 1 output, it would put 500w into it.

    If I use 1 output to a single 8 ohm cab, and the other output to another 8 ohm cab, the total load is 4 ohms, each cab is gettin 400w (half of 800), and this is a parallel connection?

    Is that the correct way to hook up my two 8 ohm cabs? Is any of that wrong?

    Thanks in advance.
     
  2. BrBss

    BrBss

    Jul 9, 2010
    Albuquerque NM
    Sounds correct.
     
  3. You have it all exactly right.
     
  4. will33

    will33

    May 22, 2006
    austin,tx
    Yeah, that's right. Running two cords out of the head, one to each cab, or running one cord from the head to the first cab, then a second cord from the first cab to the second one will give you the same 4 ohms either way.

    You could also run the head to a single 4 ohm cab, but then you're at your limit. Can't add a second cab to that.
     
  5. Dave W

    Dave W

    Mar 1, 2007
    White Plains
    Yes sir. Exactly right.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.