1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

REMOVING FEET FROM EBS WAH ONE

Discussion in 'Effects [BG]' started by attackbass, Apr 8, 2009.


  1. attackbass

    attackbass

    Jul 16, 2007
    Endorsing Artist:Orange Amps, EBS FX, Ernie Ball, Fender Bass Guitars
    So, i just removed the feet from my ebs wah one so i could velcro it to my pedalboard.

    I had to put the screws back into the base plate to secure it back to the pedal, i'm just slightly concerned that now the rubber feet aren't there the screws might be going into the pedal too deep... altho it seemed to have 'tunnels' for screws to go into, so i may be worrying about nothing...

    anyone else done this with the wah one!

    P.s the pedalboard I made by hand and looks pretty good if i say so myself - just need to add handles and ill post some pics!
     
  2. RCCollins

    RCCollins Supporting Member

    Mar 23, 2008
    San Diego, California
    looking forward to the pics!
     
  3. take it apart and check it out!
     
  4. attackbass

    attackbass

    Jul 16, 2007
    Endorsing Artist:Orange Amps, EBS FX, Ernie Ball, Fender Bass Guitars
    it seems to be going into kinda tunnels desigend for taking the screws i would think... doesnt seem to be near the electronics inside.
     
  5. timmo97

    timmo97

    Jan 17, 2009
    Iowa
    Use shorter screws.
     
  6. attackbass

    attackbass

    Jul 16, 2007
    Endorsing Artist:Orange Amps, EBS FX, Ernie Ball, Fender Bass Guitars
    the screws went in - as long as i dont get shocked and it doesn't stop working it should be fine. i may check with my person at ebs tho!
     
  7. Kooldac

    Kooldac

    Oct 20, 2008
    Arizona
    I own one. The holes are pre-made with the chassis. There is absolutely no grounding issues to worry about nor any worries about "going too far".
     

Share This Page