1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

Replaced pickup in Musicmaster and now problems

Discussion in 'Pickups & Electronics [BG]' started by black57, Sep 14, 2008.


  1. black57

    black57

    Jul 12, 2008
    I recently replaced the old jazz pickup in my bass yesterday due to the old one having low output. Now the bass has plenty of output but a lot of hum and noise. Also, the volume and tone knobs dont work as well and mainly act as an on off switch.This was my first pickup change and while im happy that it kind of worked, I would like it working close to perfectly. Im sure I soldered one of the wires wrong and would like to know where to solder the white wire to reduce hum and fix the controls. Oh and I did solder the black wire to the back of the volume pot if that makes a difference. Thanks
     
  2. EddieN

    EddieN

    Mar 21, 2007
    Check the ground wire from the bridge. :meh:
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.